Tala does not take responsibility for damage to any part of the product or installation if the following instructions are not followed.
LAMPS & FIXTURES
Please retain all product information and instructions for the lifespan of the product
ALWAYS turn off power at the mains and allow the lamp or fixture to cool fully before commencing maintenance. - When installing your fixture, follow all necessary health and safety standards for height access
DO NOT pull or expose the fixture cable to excessive force. - It is advised to clean all products regularly to remove dust build-up and ensure maximum product efficiency. - It is recommended to use a light feather duster or a clean and dry lint-free cloth to prevent the excessive build-up of dust and dirt on the surface of the glass
If a more thorough clean is required, ALWAYS remove the lamp from the fixture before commencing maintenance. - When handling the lamps, wear gloves to ensure no oil or grease is transferred to the glass surface as this can damage the surface finish and weaken the glass itself. - Handle the lamp or fixture with care at all times. It is recommended to hold the lamp by the metal screw base where possible.
NEVER use solvents or abrasives during maintenance of the lamp or fixture.
NEVER expose any part of the lamp or fixture to water or moisture.
When cleaning the lamp, be careful not to rub vigorously as the protective and decorative surface coatings can be removed.
DO NOT over-tighten the lamp to the fixture and make sure to allow a small amount of flex.
Once the lamp is installed in the fixture, check it is secure before turning the power on.